EMO 2013 – DRIVE-CLiQ connection on Fagor absolute linear and angular encoders with Siemens systems

Fagor Automation has implemented the connection to Siemens systems (Sinamics,etc.) throught the DRIVE-CLiQ interface on its linear and angular encoders.

Fagor has been awarded the Siemens certificate for all its linear encoders series L, G, S/SV, and angular encoders with an outside diameter of 90, 170 y 200 mm.

Fagor Automation offers the widest selection on the machine-tool market and it is the only one offering absolute linear encoders of up to 50 meters with DRIVE-CLiQ interface.

The implemented solution consists in an external cable with electronics integrated into the circular connector that can be used for the entire range of Fagor encoders. This aspect should be especially mentioned because its design is universal allowing a single product to be connected to both linear and angular encoders. Its high protection degree, IP67, its small size and the 8-pin M 12 connection to the Siemens DRIVE make it possible to install it even in very confined spaces.Imagen 031

Among its main characteristics, we should mention a resolution of 10nm on linear encoders and up to 27 bits on angular encoders. A special mention deserves the fact that this resolution is offered in a measuring travel of up to 42 meters and it is even available for longer lengths if our customers so require.

The official launch at the EMO machine-tool show that will take place in Hannover (Germany) from September 16th to the 21st 2013. Those of you visiting the Fagor booth (Hall 25 C44) will enjoy the exposition especially design to show the full range of encoders with DRIVE-CLiQ connection.

5

TRADE MARK copia

Emo hannover

 

 

Schreibe einen Kommentar